Troubleshooting Guide - RIDGID CM1450 Manual Del Usuario

CM1450 14" Abrasive Cut-Off Machine
made by Ridge service facilities are warranted against
defects in material and workmanship.
When servicing this abrasive cut-off
WARNING
machine, only identical replacement parts should be
used. Failure to follow these instructions may create a risk
of electrical shock or other serious injury.
If you have any questions regarding the service or repair
of this machine, call or write to:
Ridge Tool Company
Technical Service Department
400 Clark Street
Elyria, Ohio 44035-6001
Tel: (800) 519-3456
E-mail: TechServices@ridgid.com
For name and address of your nearest Independent
Authorized Service Center, contact the Ridge Tool Com-
pany at (800) 519-3456 or http://www.ridgid.com
Chart I. Troubleshooting
Motor
PROBLEM
Motor does not start
Brush sparking when
switch released
Motor stalls easily
CAUSE
Fuse
Brushes worn
Other
Low voltage
Normal automatic brake working properly
Low voltage
Excessive wheel pressure when cutting
Ridge Tool Company
CORRECTION
15 amp time delay fuse, or circuit breaker
See "Maintenance" section
Get authorized RIDGID service
Check power supply for proper voltage and correct
as needed
None
Check power supply for proper voltage and cor-
rect as needed
Pull wheel through work at a slower pace
11