Dubbing - Tascam 202 MKVII Manual Del Usuario

TAPE 1 can be dubbed to TAPE 2 .
1
Load a cassette tape for playback into the
TAPE 1 compartment and a cassette tape for
recording into the TAPE 2 compartment.
2
Press the DUB START (dubbing start) button to
start dubbing.
This will start dubbing at normal speed .
During dubbing, the dubbing (NORM DUB) indicator lights on
the display .
o To start dubbing using the remote control, press both DUB
START (dubbing start) buttons on it at the same time .
o The DUB START (dubbing start) button does not work imme-
diately after the tape is fast-forwarded or rewound to the
end . Wait for 5 seconds or more before pressing the button .
When TAPE 1 playback stops, dubbing also stops automatically .
Pausing dubbing
Press the TAPE 2 PAUSE button to pause dubbing . When paused,
TAPE 1 will continue playing, but TAPE 2 will not record .
Press it again to resume dubbing .
Stopping dubbing before playback ends
Press the TAPE 1 or TAPE 2 stop (8) button .

Dubbing

o The TAPE 2 REC MUTE (record muting) can be used to record
silences (page 20) even while dubbing . (The TAPE 1 REC MUTE
(record muting) button cannot be used . )
Erasing unnecessary parts and creating spaces between songs is
possible while dubbing .
o The pitch control function is disabled while dubbing .
o The recording level cannot be adjusted while dubbing .
o Use the same procedures to dub the other side of the tape
as necessary .
o To disable mic mixing, do not connect a mic to the MIC
connector on the front of the unit . Dubbing when a mic is
connected will result in a slightly lower recording level .
23