Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
en
1. Overview
This manual contains specific information regarding the ATEX versions, supplementing the data found in the manual for the FH and SH
WARNING
Electric Pumps (code 001073142).
Read the manuals before installing and using the product.
Improper use may cause personal injury and damage to property, and lead to the forfeiture of the warranty coverage.
2. Product Description
The FHS and SHS ATEX range includes horizontal single-impeller non-self-priming electric pumps, coupled to flameproof electric motors by a rigid coupling.
In the SHS series, all the metal parts that are in contact with the water are made of stainless steel.
In the FHS series, some of the metal parts in contact with the water are made of stainless steel, others are made of cast iron.
This electric pump is suitable for use in environments with potentially explosive atmospheres, due to the presence of flammable sub-
stances in the form of gas, vapour or mist.
3. Applications
3.1
Working Limits
3.1.1 How to Read the Pump's Rating Plate
The drawings in section 10.1 enable identification of the essential data found on the rating plate.
3.1.2 How to Read the Pump's ATEX Plate
The drawings in section 10.2 enable identification of the essential data found on the rating plates.
3.1.3 Pumped Liquids, Pressures, Temperatures
These pumps are suitable for pumping hot and cold potable water and water-glycol mixtures.
WARNING
Do not use this pump to handle liquids containing abrasive, solid or fibrous substances.
Do not use this pump to handle flammable and/or explosive liquids.
Observe the working limits specified in the product's rating plates.
For special requirements, please contact our Sales and Service Department.
Maximum operating pressure:
for SHS and FHS ranges
NB. The value varies depending on the temperature of the pumped liquid (➜ section 10.3).
Liquid temperature
- for version with NBR seals :
- for version with EPDM seals :
- for version with FPM seals :
For additional information ➜ section 10.3.
3.1.4 Suction
In case of negative suction head (negative pressure on suction side) make sure that the flow resistance in the suction pipe added to the suction lift (height dif-
ference between the water source and the pump suction port) does not exceed the pump's suction capacity, as this could cause the onset of cavitation.
Make sure that the pump is always filled with water.
Do not use the pump if cavitation occurs, as its internal components could be damaged and become potential sources of fire.
For additional information ➜ section 10.4.
Make sure that the sum of the pressure on the suction side (water system, gravity tank) and the maximum pressure delivered by the
WARNING
pump does not exceed the maximum working pressure allowed (nominal pressure PN) for the pump.
For additional information ➜ section 10.5
If you pump hot water, you must guarantee a minimum pressure on the suction side to prevent the generation of steam.
WARNING
For additional information ➜ section 10.6.
3.1.5 Minimum Nominal Flow Rate
To prevent overheating of the internal pump components, make sure that a minimum water flow is always guaranteed when the pump is running.
Do not run the pump with the on-off valve shut on the delivery side for longer than a few seconds.
WARNING
For additional information ➜ section 10.7.
12
12 bar
1,2 MPa
Minimum
Maximum
- 20 °C
+ 85 °C
- 30 °C
+ 120 °C
- 10 °C
+ 120 °C
Information for installers and users
Information for installers and users
English
Publicidad
Tabla de contenido
