To Bleed The Tool - avdel T40 Manual De Instrucciones

M a i n t e n a n c e
To B l e e d t h e To o l

To Bleed the Tool:

•
Couple the short tool hoses directly onto a HydraPac or compatible hydraulic power source.
Note: Do not use long extension hoses as these will prevent the air from escaping into the HydraPac.
•
Plug in a HydraPac Test Trigger.
•
Position the tool so that the piston rod side faces vertically up.
•
Cycle a few times.
•
Reverse the vertical position and cycle again.
9