Cutting Operation - Hitachi Koki C 10FCB Manual De Instrucciones E Instrucciones De Seguridad

2. Using the vise assembly (Standard accessory)
Screw Holder
6 mm Wing
Bolt (B)
Fence
Vise Shaft
6 mm Wing Bolt (A)
Fig. 16
WARNING:
Always firmly clamp or vise to secure the workpiece to the fence; otherwise the
workpiece might be thrust from the table and cause bodily harm.
CAUTION:
Always confirm that the motor head (see Fig. 1) does not contact the vise assembly
when it is lowered for cutting. If there is any danger that it may do so, loosen the 6
mm wing bolt (B) and move the vise assembly to a position where it will not contact
the saw blade.

3. Cutting Operation

Adjusting Line
a
b
a
Marking Marking
a b
(pre-marked) (pre-marked)
(Front View)
Fig. 17
WARNING:
* Confirm that the trigger switch is turned OFF and the power plug has been removed
from the receptacle whenever the tool is not in use.
* When you cut the workpiece, avoid any cutoff thinner than the clearance between
the cutting edge and the saw blade. Otherwise, the cut-off material can enter the
clearance between the cutting edge and the saw blade and scatter around you,
resulting in an injury.
CAUTION:
* Increased pressure on the handle will not increase the cutting speed.
On the contrary, too much pressure may result in overload of the motor and/or
decreased cutting efficiency.
* If the handle is pressed down with excessive or lateral force, the saw blade may
vibrate during the cutting operation and cause unwanted cutting marks on the
workpiece, thus reducing the quality of the cut. Accordingly, press the handle down
gently and carefully.
(1) The vise assembly can be mounted on either the left fence
Knob
{Fence (B)} or the right fence {Fence (A)} by loosening the 6 mm
wing bolt (A).
(2) The screw holder can be raised or lowered according to the
height of the workpiece by loosening the 6 mm wing bolt (B).
After the adjustment, firmly tighten the 6 mm wing bolt (B) and
Vise Plate
fix the screw holder.
(3) Turn the upper knob and securely fix the workpiece in position
(Fig. 16).
Workpiece
(1) As shown in Fig. 17 the width of the saw blade is the width of
b the cut. Therefore, slide the workpiece to the right (viewed from
the operator's position) when length b is desired, or to the left
when length a is desired.
(2) Once the saw blade reaches maximum speed, push the handle
down carefully until the saw blade approaches the workpiece.
(3) Once the saw blade contacts the workpiece, push the handle
Workpiece
down gradually to cut into the workpiece.
(4) After cutting the workpiece to the desired depth, turn the power
tool OFF and let the saw blade stop completely before raising
the handle from the workpiece to return it to the full retract
Table Insert
position.
English
15