Operating The Saw; Battery Pack And Charger - Oregon CS250 Manual De Instrucciones

OPERATING THE SAW

OPERATING THE SAW

BATTERY PACK AND CHARGER

WARNING: DO NOT CHARGE THE
BATTERY PACK IN THE RAIN.
BATTERY PACK LED CHARGE-LEVEL
INDICATOR
The lithium ion battery pack is equipped
with an LED charge-level indicator To test
the charge level of the battery pack, press
the indicator button on the battery pack's
face (Fig 8)
No lights: recharge
One steady green light:
less than 25% charged
Charge battery pack before use
Two steady green lights:
26–50% charged
Three steady green lights:
51–75% charged
Four steady green lights:
76–100% charged
FIG. 8
INDICATOR BUTTON
INDICATOR LIGHTS
CONNECTING THE CHARGER
Connect the charger cord to the charger
and to the proper electrical outlet (Fig 9)
FIG. 9
16
OREGON® CORDLESS TOOL SYSTEM
CHAIN SAW MODEL CS250
Only use the cord set that was supplied
with the charger At first use, verify that
the plug type matches the receptacle
CHARGER LED CHARGE-STATE
INDICATOR
The battery charger is equipped with an
LED charge-state indicator that indicates
the state of charging as well as conditions
that may delay or prevent charging
(Fig 10)
Note: Until a battery pack is inserted, no
lights will be visible
Blinking orange light: a fault
condition exists There are
several potential causes See
"Troubleshooting" in this manual
Steady orange light: the battery
pack temperature is beyond the
acceptable range (32°F/0°C to
104°F/40°C) Allow the battery pack
to reach the acceptable
temperature range before
charging The pack may be left on
the charger as the temperature
adjusts Charging will begin when
the proper temperature is
reached
FIG. 10
Blinking green light: battery pack
is charging
Steady green light: battery pack is
ready for use
AF 0513 - F/N 547361