Tv Menu Messages; Remote Control Problems - Dell W3207C Manual De Propietario

TV Menu Messages

While using your TV, the following messages may appear.
Message
Auto Adjust
Out of Range
No Video Input
TV Buttons Locked
In Power Save Mode
Press any key on keyboard
or move mouse
Self Test

Remote Control Problems

Problem
The TV does not respond when using
the remote control
DELL CONFIDENTIAL – PRELIMINARY 6/30/06 – FOR PROOF ONLY
38
Troubleshooting Problems With Your TV
FILE LOCATION: C:\Documents and Settings\cherylyuan\Ƈ¦±\FM\ch5e.fm
Possible Solution
No action required, the TV is performing an auto adjustment.
Check the optimal resolution settings.
You may need to download a new video driver. For more
information, go to support.dell.com.
To unlock, press Menu on your remote control, select Setup.
If you have a computer connected to the TV display and there is no
signal detected, the TV display goes in to sleep mode. The power
light is amber when the TV display is in sleep mode.
Appears for computer source when there is nothing plugged in.
Select VGA from Input Select menu and nothing is plugged in.
Plug a computer in to the VGA connector.
Possible Solution
Check all cables are properly connected.
1
Ensure the proper source is selected. See "Input Select" on page 26
2
for more information.
Point the remote control directly at the lower right corner of the
1
TV display. Be sure that nothing is blocking the front of the TV
display. For the location of the IR, see "Front View" on page 5.
Verify that the batteries are properly installed.
2
If the batteries are old, install new batteries.
3
NOTE:
Bright lights or other infrared devices may interfere with
your remote control and IR on the TV display.