Machine Inspection - Surtek PVC765 Manual De Usuario Y Garantía

· Correct moisture content in soil is vital to
proper compaction. Water acts as a lubricant
to help slide soil particles together. Too little
moisture means inadequate compaction; too
much moisture leaves water-filled voids that
weaken the soil's load bearing ability.
· The optional water tank kit is recommended
when the machine is used on bituminous sur-
faces as the water flume prevents a build up of
material on the underside of the plate.
CAUTION: Inspection and other services
should always be carried out on hard and level
ground with the motor shutdown.
INSPECTION AND MAINTENANCE SERVICE
TABLES:
To make sure your plate compactor is always
in good working condition before using, carry
out the maintenance inspection

MACHINE INSPECTION

Starting check (every day).
Loosened of lost screws (every
day).
Damage of any part (every
day).
Function of controlling system
part (every day).
Vibrator oil check
Vibrator oil replacement
V-belt (Clutch) Check
MOTOR CHECK
For details, see separate motor manual.
Leakage of oil fuel (every day)
Tightness of fastening threads
(every day)
Engine oil check and replen-
ishment (every day) (Replen-
ish to specified Max. Level)
Engine oil replenishment
Air cleaner cleaning
for operation under normal conditions. Adjust
your inspection intervals based on the number
hours plate compactor is in use, and particular
Every 8 hrs
working conditions.
Every 8 hrs
should be replaced every 2 years.
Daily Service
Every 8 hrs
• Check for leakage of fuel or oil. Remove
soil and clean the bottom of compaction plate
Every 8 hrs
• Check motor oil. Check for loose screws in-
cluding tightness. See Table below (Tightening
Every 100
torque), for retightening.
hours
Material
Every 100
4T
hours
6-8T
Every 100
11T
hours
11T
(In case counter-part is of aluminum)
(Threads in use with this machine are all right handed)
Material and quality of material is marked on each bolt, and screw.
Changing Vibrator Oil
When changing the vibrator oil, remove the
drain plug located at the bottom-right of the
vibrator, and simply tip the compactor to drain
the oil. Note that the oil will drain more easily
while it is hot. Replace the oil with 200 ml of
SAE 10W-30 motor oil.
E N G L I S H •
CAUTION: These inspection intervals are
CAUTION: Fuel piping and connections
6 mm 8 mm 10 mm 12 mm
70 150 300 500
100 250 500 800
150 400 800 1200
100 (6 mm) 300 - 350 (8 mm) 650 - 700 (10 mm)
U se r ' s m a n ua l
Every 8 hrs
Every 8 hrs
Every 8 hrs
At first 20
hours, then
every 100
hours
Every 50
hours
14 mm 16 mm 18 mm 20 mm
750 1100 1400 2000
1300 2000 2700 3800
2000 2900 4200 5600
13