Exterior Cleaning; Interior Cleaning - Avanti IMC132A3S Manual De Instrucciones

Exterior cleaning

The door and cabinet may be cleaned with a mild detergent and warm water solution such as 1 oz. of
dishwashing liquid mixed with 2 gallons of warm water. Do not use solvent-based or abrasive
cleaners. Use a soft sponge and rinse with clean water. Wipe with a soft clean towel to prevent water
spotting.

Interior Cleaning

The ice storage bin should be sanitized occasionally. Clean the bin before the ice maker is used for
the first time and reused after stopping for an extended period of time. It is usually convenient to
sanitize the bin after the ice making system has been cleaned, and the storage bin is empty.
1. Disconnect power to the unit.
2. Open the door and with a clean cloth, wipe down the interior with a sanitizing solution made of
1 ounce (29.5ml) of household bleach or chlorine and 2 gallons (7.5L) of hot water 95ºF (35
ºC) to 115 ºF (46 ºC).
3. Rinse thoroughly with clear water. The waste water will be drained off through the drainpipe.
4. Reconnect power to the unit.
The ice scoop should be washed regularly. Wash it just like any other food container.
DO NOT use solvent cleaning agents or abrasives on the interior.
These cleaners may transmit taste to the ice cubes, or damage or
discolor the interior of the machine.
Minerals that are removed from water during the freezing cycle will eventually form a hard-scaly
deposit in the water system. Cleaning the system regularly helps remove the mineral scale buildup.
How often you need to clean the system depends upon how hard your water is. With hard water of 4
to 5 grains/liter, you may need to clean the system as often as every 6 months.
1. Turn off power to the ice maker. Keep the ice maker connected to the water supply and
drainpipe.
2. Open the door and scoop out all of the ice cubes. Either discard them or save them in an ice
chest or cooler.
3. Turn on the power to the ice maker. Pour 8 ounces of Nickel-Safe Ice Maker Cleaning
Solution into the water bin. Add 8 ounces of tap water. After about 5 minutes, press down the
"clean" button on the Control Box. (See figure below and following section.) The machine will
run the Automatic Clean Mode.
The ice machine cleaner contains acids.
DO NOT use or mix with any other solvent-based cleaner products.
Use rubber gloves to protect hands. Carefully read the material safety instructions on the
container of the ice machine cleaner.
DISCARD the first batch of ice produced after cleaning.
14