Step 7 - Ledge Piece And Cover Installation - Trigano PISCINES ABAK OSMOSE Serie Instrucciones De Montaje

From inside the pool, place the gaskets and the discharge nozzle (Figure
4) and screw the tightening ring on the outside of the pool.
Screw the threaded nipple with Te on.
Install the ringed hose and the hose clamp.
Connect the ringed hose to the valve (pool return) on the sand puri er
(threaded nipple with Te on and hose clamp) see Step 8.
B – Skimmer Installation
When the water level in the pool is 5 or 6 cm below the skimmer, assemble
the skimmer as follows (Figure 5):
Pressing on the liner (using a pen cap for example), nd the pre-cut holes in
the wall.
Punch the holes using a Phillips screwdriver.
Present the rubber gaskets as per Figure 5.
Present the ange (or frame) on the rubber gasket.
Screw the ange to the wall (YY).
Screw the threaded nipple with Te on.
Tighten the hose on the skimmer using the hose clamp.
Cut the liner blocking the skimmer from inside the pool.
Connect the ringed hose from the skimmer to the ltration pump.
Let the water level rise up to the middle of the skimmer.
Final sealing will only be obtained once all the screws have been
progressively and steadily tightened.
Step 7 : Ledge Piece and Cover Installation
The ledge pieces (AA) have a mounting direction.
The ledge pieces (AA) are placed between the posts (BB).
Screw the ledge piece (AA) onto the upper connecting plate (820 121).
You may need to gently move the post (BB) to the left or right to install the ledge piece (AA).
Only block the screws when they have all been installed.
Screw the ledge piece covers (DD) on the connecting plate (820 121) and clip the caps (HH)
in the hole provided for this purpose.
AA
BB
121 305
9,50
DD
POOL INTERIOR
POOL INTERIOR
FLANGE
LINER
ringed
hose
Pool
exterior
HH
121 307
67 Notice N°880101 Rev B
Figure 4
stop valve
collar
ringed
POOL EXTERIOR
hose
Figure 5
GASKETS
POOL EXTERIOR
SKIMMER
WALL
stop
collar
valve
Ledge piece pro le
DD
16
121 375
11