Pool Disassembly; Winterizing Guidelines; Warranty - Trigano PISCINES ABAK OSMOSE Serie Instrucciones De Montaje

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 72

2: Pool Disassembly

We strongly recommend you do not disassemble your pool. Nevertheless, in case of absolute necessity, if you must disassemble your
pool, conduct the assembly sequences in reverse.
WARNING
Disassemble the pool taking the following precautions:
Empty the pool by siphoning with a hose or using the sand lter pump.
Wash all elements with soap.
Do not use agents containing soda to wash the liner.
Rinse with water and dry all elements (in order to avoid puncturing the liner, only clean it within the pool; it should be dried in the shade, as
soon as possible. Do not subject it to extended exposure to the air).
In case of damage (punctured liner), it may be easily repaired, even in the water, with a special liner repair adhesive.
A disassembled liner may not be reused.
Roll-up the metal wall without folding it and tie with a small rope.

3 : Winterizing Guidelines

Do not empty your pool.
Remove oating debris (leaves, small branches, insects, etc.) using the net.
Clean the bottom of the pool using a vacuum brush (or venturi).
Check the pH using a test kit and adjust as necessary.
Use a winterizing agent based on the pool's water volume (see explanatory not on the product label).
Run the lter for about 4 hours.
Lower the water level to below the skimmer opening.
Thoroughly drain the ltration unit (pump and tank) and store it in a location protected from freezing.
Place a cap on the discharge nozzle and unhook the hoses (not included with the kit).
Place oaters on the water (not provided).
Cover the pool with a winter cover.
WARNING

4 : warranty

Our pools are guaranteed for 2 years for the structure and accessories unless otherwise stated on the packaging, against defects in work-
manship under normal use, excluding wear parts.
This warranty is limited to exchanging defective parts with your reseller.
Liners are warranted for two years solely for seam defects (peeling). The warranty shall not cover holes due to improper handling during
assembly or using unsuitable treatment agents. Porosity and discolouring issues are caused by misuse or unsuitable treatment agents. The
lters are warrantied for two years under normal use and in compliance with the assembly instructions except for seals and wear parts. The
cartridges are not warrantied.
The warranty does not apply if the pool is in-ground or semi-in-ground.
WARNING
Do not lift the liner when it is still lled with water.
If you do not cover your pool and the water freezes, never break the ice so formed.
When it is cold, you may place a oating object in your pool in order to minimize the pressure
caused by the ice formation.
For the warranty to be valid, you must retain proof of purchase including the reseller's stamp as
well as the purchase date and the quality control sheet. You must change all damaged items or
set of items as soon as possible. Only use Trigano Jardin approved parts.
In order to take advantage of your warranty,
please register it directly on our Internet site
www.triganojardin.com
70 Notice N°880101 Rev B
14

Publicidad

Tabla de contenido
loading

Productos relacionados para Trigano PISCINES ABAK OSMOSE Serie

Tabla de contenido