Operation And Use; Setting Up The Device; Battery Test - Tool it PBT 600 Manual De Instrucciones

Translation of the original instructions

OPERATION AND USE

1- Ensure that the area is well ventilated before performing a test.
2- Tester for 12 V batteries and systems for 12 & 24 V charging (Only 12 volt for START & STOP batteries)
3- Before running a test on the battery, make sure the ignition is off, the accessories are also off.
Close all the doors and the boot.
4- Recommended operating temperature: From 0°C (32°F) to 50°C (122°F)
5- Make sure the battery terminals are clean. If necessary, clean them using a wire brush.
Any presence of oxidation between the tester terminals and the battery connectors or between the battery connectors
and the battery terminals reduces the effectiveness of the tester.
6- Make sure that there is a 9 V Alkaline battery in the battery compartment (see diagram below).
Remove the protective cover
7- Connect the negative (black) terminal to the negative terminal of the battery. Connect the positive plug (red) to the
positive terminal of the battery.
To test a 24V system (2 x 12 V), test one battery at a time. The test procedure is identical to that of a 12V battery.

SETTING UP THE DEVICE

Access to the items is via the (X) keys and then confirm the selection with the OK key:
1- See results : Allows you to display all the test results performed.
2- Print : Function to print the results of previously saved tests.
3- Voltmeter : This function allows you to adjust the voltage display on the device's home page. By pressing «OPEN»,
the battery voltage shows on the home screen. By pressing «CLOSE», the battery voltage does not show on the home
screen.
4- Thermometer : Displays the room temperature.
5- Thermometer unit : Allows the selection of the thermometer measurement unit (Celsius or Fahrenheit)
6- QC mode : By selecting «Reset», the QC mode erases all data recorded on the unit. Consequently, the display of
results in «see results» will be deleted.
7- Customer entry code : this function allows you to activate or deactivate a customer entry code. Once the configu-
ration is successful, the screen displays «OK».
8- Choose language : To change the language, scroll through the menu and press OK to confirm
9- Date and time format : Use the arrows to scroll through the different date and time presentations.
10- Date and time adjust : Use the arrows to change the year. Click on OK to confirm the year. Do the same procedure
for the date and time.
11- User information : This function allows you to enter customer information (e.g. company name, reference num-
ber, telephone, etc.). This information is also displayed on the test ticket. To enter information, use the arrows and scroll
through the letters/numbers, click OK and carry on.

BATTERY TEST

From the home screen, perform a quick test by pressing the back arrow. For a prolonged test :
1. Press OK to start a test
2. Choose between «INT vehicle» or «EXT vehicle» depending on the location of the battery (indoor or outdoor)
then OK.
3. Select «before charging» for a cold vehicle or «after charging» for a warm vehicle.
5. Select the type of battery using the arrows
6. Choose the battery standard (EN, CCA, BCI, CA, MCA, JIS, DIN, IEC, SAE, GB)
7. Enter the starting current indicated on the battery («A»)
8
PBT 600
Unscrew the battery
compartment
Remove the battery by leve-
ring it out with a screwdriver
EN
Replace a new battery
9V in the compartment