How To Use - Tool it PBT 60 Manual De Instrucciones

PBT 600 – Battery Conductance Testeur

How to Use:

1. Before Testing:
 Clean battery poles with metal wire brush and alkaline cleaner to avoid the tolerance
caused by oil and dust to the test result.
 For Group31 or side-installed battery, connect and fix the terminal wiring connector.
Otherwise, inaccurate test result will be caused due to wrong installation or dirty or
bad wiring connectors.
 While testing, ensure none of the in-vehicle electrical appliance is on, doors are
closed and the ignition key is in OFF status.
 Connect the red test clamp with battery anode and the black test clamp with cathode.
Shake the clamps back and forth to make sure they are well
connected.Tester requires the two clamps are well connected with the
battery poles, otherwise, the test cannot go on. When enter the
battery test program, screen prompts "Check Connection" (See
below picture).Do clean the poles and re-connect in the right way.
Tester has reverse connection protection function. When clamps
are reversely connected, tester will prompt "Reverse Connection"
(See above picture), but it damages neither the tester nor the
automotive load.
NOTE: For parallel connected batteries, break off the cathode connection first,
then do single test to each battery.Suppose cathode connection is not cut off, there
will be error in test result.
2. Key Description
Return key－Return to
previous menu
MENU key－ Enter the
additional function
program
Down Key
UK - 5
UP Key
OK Key－Confirm the
selection
Power key－Turn on/off
the tester