Avanti CIM102U3S Manual De Instrucciones página 18

Notice:
Do not use too much force, as the wire leads connected to the power switch can be
inadvertently disconnected. Use care in the area of the control box. Do not expose it to moisture.
4. Turn on the power to the ice maker. Pour 8 ounces of Nickel-Safe Ice Maker Cleaning
Solution into the water bin. Add 8 ounces of tap water. After about 5 minutes, press down the
"clean" button on the Control Box. (See figure below and following section.) The machine will
run the Automatic Clean Mode.
Allow 30 minutes for proper cleaning. After cleaning, shut off the
power switch, and unscrew the nut of the water-draining hole. Drain off
the waste water to some container, and then screw the nut on tightly
when the waste water is fully drained off.
5. The dirty water must be drained out completely. Perform steps
2 and 3 in the Interior Cleaning section.
6. Repeat steps 4 and 6 above 3 times (without Ice Maker
Cleaning Solution) to rinse the ice making system completely.
Note: The use of the Ice Maker Cleaner Solution in the water
bin during the rinse is not needed.
7. Reassemble the front cover.
8.
Turn on the power again. The machine will return to the regular ice making mode. Discard the
first batch of ice.
The ice machine cleaner contains acids.
DO NOT use or mix with any other solvent-based cleaner products.
Use rubber gloves to protect hands. Carefully read the material safety
instructions on the container of the ice machine cleaner.
DISCARD the first batch of ice produced after cleaning.
18