Hemstitch And Edging; Sewing Hemstitch; Sewing Narrow Edging - Silvercrest KH 4300 Instrucciones De Uso

Máquina overlock
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Pin

Hemstitch and edging

For these two tasks proceed as follows:
1. In the section "Adjusting the sewing foot" reread
the instructions for adjusting the sewing foot o.
2. Turn the handwheel 6 to yourself until the needles
stand fully at the top.
3. Open the front flap 8 and remove the left needle
(see section " Exchanging needles").
4. Adjust the stitching length to 1.0 - 2.0 mm. Ensure
that the adjustment wheel for the differential
feed motion u is placed at "N".
5. Adjust the stitching width as described in the sec-
tion "Setting the cutting width".
6. If a yarn is not threaded, now rethread a new
yarn.
7. Lay your material under the sewing foot o and
start to sew.
Note:
Before you begin to sew on your actual workpiece,
always check the adjustments for stitching length
and thread tension on a material remnant.
Note:
Always remember to return the adjustment for the
sewing foot o from this special to normal operation
(sewing tasks) after the sewing of hems.

Sewing hemstitch

With the sewing of hemstitches the loops of the upper
looper thread should be pulled back to the underside
of the material. This is achieved by adjustment of the
thread tension, as described in the section "Setting
the thread tension".
lower
looper thread

Sewing narrow edging

If you wish to sew very thin or light materials, select
a suitable thread tension, as described in the sec-
tion "Setting the thread tension".
needle thread
- 61 -
upper
looper thread
upper
looper thread
lower
looper thread

Publicidad

Tabla de contenido
loading

Tabla de contenido