Operation; Maintenance; Cleaning & Maintenance - Omcan BC-CN-0170-C Manual De Instrucciones

Installation
and screw the wing nut with the rubber washer. Tighten it firmly by hand.
3. Attach the CO line end of the tube to the hose connection on the tap. Next, secure the tube by using the
2
remaining self locking plastic snap on clamp to ensure that there are no leaks. Secure the clamp tightly with
pliers.
4. Make sure the beer tower faucet is in the closed (handle pointed straight back) position before connecting
the tap to the keg. To secure the tank connection, pull the tapping handle out and push down until it locks
into position. Listen for the click of the pull handle when it shifts into the final downward position. This will
open the beer and CO
5. Carefully tilt the keg and rest the edge on the keg floor support on the bottom of the interior cabinet. Slide
the beer keg slowly, ensuring that it is properly located and carefully close the door.
6. Your beer keg fridge comes with a 2.5lb. (1.1kg.) CO2 bottle, which should be able to dispense 4 - 15Gal/
56.8L kegs of beer.

Operation

OPERATING YOU BEER KEG FRIDGE
Dispensing Beer
Follow the steps below to dispense beer.
1. Make sure that the beer keg fridge is plugged in properly to a 120V, 60Hz, 16 Amps grounded AC power
outlet.
2. Place the drip tray under beer faucet to avoid messes from excess beer.
3. Open the beer faucet by pulling the tap towards you to dispense the beer.
Note: If for any reason the beer does not come out of the tap, please refer to the Tapping the Beer Keg
section.
4. Increase the pressure if the beer runs too slowly.
5. Hold the glass steady at a 45° angle, when it is 2/3 full, straighten the glass. Proper foam should be a tight
creamy head and the collar on an average glass should be 3/4" to 1" high, ideally.
Note: It is normal to see condensation from on the faucet. It is caused by the difference of temperature
between the cold beer and the inside of the faucet when the beer is flowing through the line.

Maintenance

CLEANING & MAINTENANCE
Flushing the Tubes
Follow the steps below to clean the keg tap and hoses.
1. Turn off CO completely before attempting to clean.
2
2. Remove the hose from the coupler and carefully twist the dispenser faucet off the top of the beer keg
gas valves. The keg is now tapped.
2
8