Charging - Stihl AR 2000 L Manual De Instrucciones

Ocultar thumbs Ver también para AR 2000 L:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8 Charging the Backpack Battery
WARNING
Since the charger heats up during the charging process, do
not operate the charger on a combustible surface or in a
location where combustible gases, liquids, vapors, dusts or
other materials and substances are present.
To set up the charger:
1
► Insert the plug (3) into a properly installed wall outlet (4)
matching the voltage and electrical frequency stated on
the rating plate on the charger.
The charger runs a self-test immediately after it is plugged
in. The charger LED (1) will glow green for about 1 second,
then it will glow red briefly before going out. Once the LED
goes out, the self-test is complete and the charger is ready
to charge the battery.
► Position the power supply cord (2) so that it will not be
stepped on, tripped over, come in contact with sharp
objects or moving parts or otherwise be subjected to
damage or stress.
8.2

Charging

WARNING
STIHL batteries contain safety features and devices which,
if damaged, may allow the battery to generate heat, rupture,
leak, ignite or explode. Never charge a malfunctioning,
damaged, cracked, leaking or deformed battery or use a
charger that has been damaged, @ 5.2. Never insert a wet
0458-820-8621-A
4
3
2
AP Adapter. Never use a wet charger, @ 5.2. Follow all
product-specific warnings and instructions accompanying
your charger.
To charge the battery:
► Attach the connecting cord to the battery.
3
3
1
2
► Push the plug of the connecting cord (1) into the
socket (2) of the AP Adapter (3) until it stops.
► Push the AP Adapter into the charger (5) until it stops.
The LED on the charger (4) glows green when the battery
is charging.
The LEDs on the AR battery glow green and show the
state of charge.
When the LEDs on the battery turn off, the charging
process is complete and the charger will shut itself off.
► Remove the AP Adapter from the charger and disconnect
the charger's power supply cord from the electrical outlet
when charging is complete.
A battery is not fully charged when it ships from the factory.
STIHL recommends that you fully charge the backpack
battery before using it the first time.
Operate the charger indoors in a dry room. For optimum
performance, STIHL recommends operating the charger
within an ambient temperature range of 41 °F to 104 °F
(5 °C to 40 °C).
English
4
5
11

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Ar 3000 l

Tabla de contenido