Assembly; Fitting The Handlebar; Adjusting The Clutch Wire; Dismantling And Assembling The Cutter - Husqvarna LB448S Manual De Instrucciones

Fitting the handlebar

Take care not to damage the cables and wires when you
fold the handlebar.
The upper part of the handlebar is attached with a sturdy
handle nut on the baffle plate. Don't forget the washer
between the plate and the handle nut.
If necessary, the handle can be turned slightly sideways
with the handle joint. The handle can be set to different
positions to achieve the best driving position, e.g. when
mowing next to hedges or house walls.
The handle can also be adjusted vertically by turning the
wheels by the attachment fitting on the chassis

Adjusting the clutch wire

The clutch wire must be adjusted after the first 8 hours of
operation and subsequently when necessary.
The wire is properly adjusted when the wire bracket is
aligned with the nut.
8 – English

ASSEMBLY

• Adjust the wire using the adjuster screw. Unscrew the
screw clockwise or counter clockwise to extend or
shorten the wire.
Dismantling and assembling the
cutter
!
The ignition lead should always be removed from the
spark plug before repair, cleaning or maintenance work.
Position the cutter with the spark plug upwards when
servicing the machine.
Always empty the fuel tank before you place the lawn
mower on its side.
Dismantling
• Unscrew the bolt holding the cutter.
• Remove the bolt, spring washer and cutter.
WARNING! Always wear heavy-duty
gloves when servicing and maintaining
the cutting equipment. The cutters are
very sharp and cuts can occur very
easily.