Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
BACKGUARD INSTALLATION
The backguard acts as a heat vent for the oven and
must be installed before the appliance is used.
1. Remove the two screws from the back of the
appliance.
2. Align the backguard with the screw holes and
attach it to the appliance using the screws.
DIMENSIONS
This dimensions of this appliance are:
A. 41 inches (104 cm) from the fl oor to the top of
the backguard
B. 36.2 inches (92 cm) from the fl oor to the
cooktop
C. 25.5 inches (64.8 cm) deep
D. 23.4 inches (59.5 cm) wide
It is the installer's responsibility to comply with
installation clearances specifi ed in the manual.
The minimum cabinet opening dimensions and
clearances must be used. The minimum spacings
must be maintained between the appliance cooking
surface and the horizontal surface above the
cooktop.
30 inches (65 cm) is the minimum clearance
between the top of the cooking surface and the
bottom of an unprotected wood or metal cabinet.
LEVELING INSTRUCTIONS
The appliance must be level to operate safely and
properly. There are four leveling legs located at
the corners of the bottom of the appliance. Adjust
the leveling legs until the appliance is level. Use a
carpenter's level to confi rm.
A
B
C
7
D
Publicidad
Tabla de contenido
Solución de problemas
