Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALL FILTERS
hood. These channels will hold the charcoal filters and
stainless steel grease filters in place.
Install charcoal filters
rear of the opening. Grasp the filter tab, lift and pull
forward until it rests in the front upper channel.
Install grease filters
the opening. Push back, lift and pull the knob forward
until the filter rests on the channel.
adjust the right-side filter in the channel to engage the
switch arm.
FINALIZE INSTALLATION
Remove protective film covering the control panel
on the front face of the hood and any remaining
packaging materials.
installed and the filter light is not on.
Installation Instructions
INSTALLATION – RECIRCULATING
upper (top) channels at the
Upper charcoal
filter channel
Lower charcoal
filter channel
Upper charcoal
filter channel
Lower
filter channel
the Owner's Manual for operating instructions
and the Problem Solver.
21
Grasp tab,
lift and pull forward
Publicidad
Capítulos
Tabla de contenido
