Final Setup; Important Considerations - Heath Zenith 5835 Manual De Uso

the selected lights. Note: The TEST mode overrides the photocell (daylight shutoff feature) and allows the light
fixture to be tested day or night.
3. Walk in front of each light to ensure all linked lights are activated from another linked light. Note: The linked lights
may not come on at the same time because of the delay of the transmission signal.
1. When testing is complete, set the DUALBRITE switch to the desired amount of time after dusk the lights should remain
on at a reduced light level [Off, 4 Hrs., Dusk-to-Dawn (D2D)]. See DualBrite Timer section for more information.
2. The amount of time the lights stay on after ALL motion has stopped in front of ALL linked lights is preset to 5 minutes.
LINK TECHNOLOGY:
Link technology allows multiple lights to be connected together wirelessly. When one light senses motion it will turn on
full bright and send out a wireless signal. All lights within range and on the same channel will also turn on full bright.
Each time a light receives a signal, it will then repeat the signal so
other lights not in range of the first light will also turn on full bright.
Linked lights can be grouped into one of three possible channels (A,
B, or C) to create linked zones of lighting. Note: Linked lights turn
off independently of each other and may not turn off at exactly the
same time.
Illustration example: Light #1 senses motion and sends a signal. Light
#2 is out of range of light #1 and does not receive the signal. Light #3
is in range of light #1 and receives the activation signal. Light #3 is
activated and repeats the signal. Light #2 is in range of light #3 and is
activated. Note: All the lights will send out a signal when activated, even
if the light's DualBrite switch is set to OFF. If the light is in manual
mode, it will repeat any signal it receives but will not initiate a signal.
AVOID AIMING THE SENSOR AT:
• Below are examples of objects that might produce heat and may cause the motion sensor to trigger:
• Pools of Water
• Animals
If you suspect that a heat source of this type is triggering the motion sensor, reduce the sensitivity.
• Areas where pets or traffic may trigger the motion sensor.
• Nearby large, light-colored objects reflecting light may trigger the shut-off feature. Do not point other lights at the
motion sensor.
SEASONAL CHANGES:
The motion sensor works by sensing temperature changes across its field of view. The closer the surrounding tempera-
ture is to a person's body heat, the less sensitive the sensor will appear. The greater the temperature difference, the more
sensitive the sensor will appear. The sensitivity (SENS) switch might need to be readjusted as the outside temperature
changes for the different seasons. This is a normal part of the light sensor's operation.
DualBrite mode is a selectable feature that turns the light on at dusk in a reduced light level. The light will stay on at
the reduced light level for the amount of time selected [Off, 4 hr., dusk-to-dawn (D2D)]. When motion is detected, the
light will increase to full bright. The light will stay on at the full bright level for 5 minutes after ALL motion has stopped
209735-01

FINAL SETUP

IMPORTANT CONSIDERATIONS

• Air Conditioners
• Heating Vents
DUALBRITE TIMER
To see operational and troubleshooting information and videos,
go to www.hzsupport.com
2
• Dryer Vents
• Automobile Traffic
3
1
5