Specifications; Caractƒristiques Techniques; Daten; Especificaciones - dbx 286A Manual De Instrucciones

64
S / C
PECIFICATIONS
MIC INPUT
Entrée MIC
MIC-Eingang
Entrada MIC
Impedance
Maximum Level
Gain Adjustment Range
Phantom Power
CMRR
LINE INPUT
Entrée LINE
LINE-Eingang
Entrada LINE
Impedance
Maximum Level
Gain Adjustment Range
CMRR
INSERT (1/4Ó TRS phone)
Circuit d'insertion (jack 6,3 mm stéréo)
INSERT-Anschluss (6,3-mm Stereoklinkenbuchse)
Conexión INSERT (clavija jack 6,3 mm estéreo)
Ring: Impedance
Maximum Level
Tip: Impedance
Maximum Level
Noise
Distortion
LINE OUTPUT (4Ó TRS phone)
Sortie LINE (jack 6,3 mm stéréo)
LINE-Ausgang (6,3-mm Stereoklinkenbuchse)
Salida LINE (clavija jack 6,3 mm estéreo)
Impedance
Maximum Level
Gain Adjustment Range
Noise
Frequency Response
Distortion
COMPRESSOR
Circuit de compression
Kompressor
Compresor
Threshold Range
Threshold Characteristics
Compression Ratio
Maximum Compression
Attack Time
Release Time
Distortion
SMPTE Intermodulation Distortion
DE-ESSER
Characteristic
Frequency Range
Release Time
ENHANCER
HF Detail Characteristic
LF detail Characteristic
Mic Preamp/
Processor
286A
ARACTƒRISTIQUES TECHNIQUES
Floating balanced, Pin 2 Hot
Erdfrei symmetriert, Stift 2 = Inphase
1.75kΩ
0.2Vrms
+10dB ... +60dB
+48VDC, applied to XLR pins 2 and 3 through 6.81kΩ resistors
>40dB, typically 55dB
Floating balanced, TIP Hot
Erdfrei symmetriert, Spitze = Inphase
30kΩ unbalanced, 60kΩ balanced
>+21dBu, balanced or unbalanced
-20dB ... +30 dB
>40dB, typically 55dB
Normalled; tip is Send, ring is Return
Normalisé; pointe = sortie, anneau = retour
Trennklinke; Spitze = Ausgang, Ring = Eingang
>5kΩ
>+21dBu
100Ω
>+21dBu, >+20dBm (600Ω load)
<-84dBu, unweighted (20Hz-20kHz); MIC GAIN Control set to 12:00
<0.01% THD, 20Hz-20kHz, +10dBu
Balanced/Unbalanced
Symmetrisch/asymmetrisch
100Ω unbalanced, 200Ω balanced
>+21dBu, >+20dBm (600Ω load)
-30dB ... +10dB
<-80dBu (typically -85dBu, unweighted (20Hz-20kHz); Both Gain Controls set ... 12:00,
all processing controls OFF
20Hz ... 20kHz, +0.5, -0.5dB
<0.08%THD, 20Hz-20kHz, +10dBu, all Processing Controls OFF
-40dBu to +20dBu
OverEasy®
>4:1 For input levels beyond 20dB above threshold
30dB
Program-Dependent; >1s for small level increases, down to 10ms for large increases
Program-Dependent;adjustable between approximately 1dB/Sec and 75dB/Sec
Typically <0.05%THD, 20Hz-20kHz, 15dB G/R, +10dBu Output, DENSITY @ 0
<0.05%; 60Hz/7kHz 4:1, 15dB G/R, +10dBu Output Level, DENSITY @ 0
Wideband Gain Reduction
800Hz to 10kHz High Pass, 12dB/octave
Program-Dependent; approximately 1ms/dB
Program-controlled shelving equalizer, approximately 15dB maximum HF boost
Bell-shaped boost @ 80Hz, bell-shaped cut @250Hz, ratio is approximately 2:1
/ T D
ECHNISCHE ATEN
/ E
SPECIFICACIONES