Assembly; To Attach The Cutting Deck Combi 132, Combi - Husqvarna P 520D Manual De Usuario

• The product is approved only with the equipment
supplied or recommended by the manufacturer.
Introduction
WARNING: The drive belt tension spring
can break and cause injury. Wear protective
glasses when you attach or remove the
cutting deck.
Read the assembly instructions in the owner's manual
carefully. A label on the inner side of the front cover on
the product, also shows how to attach and remove the
cutting deck.
To attach the cutting deck Combi
132, Combi 155
Note: Make sure that the cutting deck is put on level
ground before you attach the cutting deck.
1. Put the lift lever to the position (B) to lower the lift
arms.
B
WARNING: Do not put the lift lever to
the mow position (A). The hydraulic force
can cause serious injury.
2. Carefully operate the product in front of the cutting
deck.
3. Put the lift arms into the joint of the cutting deck.
4. Apply the parking brake.
5. Stop the engine.
740 - 004 -

Assembly

6. Install the bolts (A) and attach the pins (B) on the lift
arms.
7. Remove the 2 screws and remove the bottom plate.
8. Pull back the coupling of the drive shaft and attach
the drive shaft to the power take-off.
Note: Make sure that the arrow on the symbol points to
the product.
9. Put the rear lock chain around the lift shaft.
10. Attach the lock chain to the drive shaft.
B
A
B
A
13