To Replace The Belt On The Cutting Deck; To Adjust The Pto-Belts - Husqvarna P 520D Manual De Usuario

2. Remove the service stay from the cutting deck.
3. Attach the service stay to the red attach point below
the bottom plate.
4. Pull the pin on the other end of the service stay.
Attach the service stay to the red mark on cross tube
on the cutting deck.
5. Start the engine.
6. Set the cutting height lever in the service position.
7. Attach 1 end of the the safety straps around the pipe
adjacent to the steering column.
34
8. Attach the other end of the safety strap around the
pivoting wheels of the cutting deck.
B
To put the cutting deck in mow position, follow the
instructions in the opposite sequence.
To replace the belt on the cutting
deck
1. Remove the 3 screws that holds the belt cover.
2. Remove the belt cover.
3. Attach the service stay to the tension spring.
4. Push the service stay and remove the belt.
5. Attach the belt around the pulleys as shown in the
illustration.

To adjust the PTO-belts

1. Release the lock nut (A).
2. Tighten the adjustment screw (B) until the sleeve is
against the frame bracket (C).
A
740 - 004 -