Troubleshooting - RCA WHP170 Manual De Instrucciones

WHP170_US_IB_REV.qxd 12/24/03

TROUBLESHOOTING

Refer to this troubleshooting section if you encounter any difficulties in
setting up and using your headphones.
PROBLEM SOLUTION
No sound heard A) Check that your audio source, recharging
through the cradle/transmitter and headphones are
headphones connected, supplied properly and turned on.
B) Check to ensure that the rechargeable
batteries are installed in the headset
correctly and have been recharged properly.
C) Check to ensure the recharging cradle/
transmitter is running and the power
indicator light on the unit is lit.
D) Check that the audio source is delivering
a sufficient signal to the recharging cradle/
transmitter's AUDIO IN input jack.
Poor sound quality A) Check to ensure that the sound provided
or interference by the audio source is loud enough and
of sufficient quality.
B) Check if the batteries in the headphones have
sufficient power. Recharge or replace them,
if necessary.
C) Check to see if you have selected the best
transmission channel (1, 2, or 3) to provide
the optimum signal reception. If necessary,
try another channel, remembering to fine-
tune the reception using the tuning control.
D) Check if the distance between the
headphones and the recharging cradle/
transmitter is within the operating range.
(The effective range of this device is up to
150 feet/45 meters from the cradle/
transmitter.)* Move closer to the recharging
cradle/transmitter to receive the sound.
E) Check that the audio source provides
stereo sound.
* Range may vary by environment.
11:22 AM Page 11
11