Publicidad
Idiomas disponibles
Idiomas disponibles
REMOTE CONTROL SETTING AND OPERATION
1. Restore electrical to the outlet box by turning the electricity on at the
main fuse box.
(Figure. 1)
2. Remove the battery cover from the remote control transmitter, install the
battery, and replace the cover.
Note:
1. Use 2 1.5V/AAA battery to replace battery. (Fig. 2)
2. If not using for long periods of time, remove the battery to prevent
damage to the remote transmitter, and store the remote transmitter
away from excess heat or humidity.
3.Universal Mode and Learning Mode:
Universal Mode: Set both DIP (code) switches to the UPPER position.
Your fan with the remote controller is ready to use. (Fig. 3)
Note: In universal mode, your fan can be controlled with other remote
transmitters with the same setting.
Learning mode: To control the fan with a specific remote transmitter, choose this
mode by setting the DIP (code) switch to LOWER position within
5 meters distance from the fan. Restore power to your fan.
Next, press and hold the "SET" bottom for about 4 seconds until
the buzzer inside of the receiver sounds. Your remote controller
is ready to operate the fan. You must press the "SET" button
within 1 minute of restoring power to the fan.(Fig. 3)
Note: If the power is on already, you must turn the power off for at least 5 seconds
before restoring power for remote control learn function setting. The buzzer
inside of the receiver will sound for about 4 seconds after turning the power
back on. This signals that it is ready for the learning function setting. If the
fan is running after turn on the power, wait for at least 5 seconds and then
press and hold the "SET" button for about 4 seconds until buzzer inside
receiver sounds. Your remote controller is ready to operate the fan.
4. The buttons on the remote control transmitter control the fan speed and light as
follows. (Fig. 4)
Press the button to get desired fan speed, Low to High.
Press the button to get desired fan speed, High to Low.
Press the OFF button to turn fan off. Fan speed will maintain last
setting if turned off.
Press this forward/reverse button to get desired airflow
direction. Fan must be running to reverse. It will take about 25
seconds for fan to slow down and change rotation direction.
Press this button to turn light on or off.
5. Install Transmitter wall mount cradle with 2 screws provided.
Move the trim plate out from wall mount cradle and install the wall mount
mount cradle with 2 screws provided. Replace the trim plate. (Fig. 5)
5
On
Off
On
Off
Fig 1
MAIN FUSE BOX
RemoteTransmitter
Battery
DC1.5VX2
Fig 2
UPPER
LOWER
DIP switches
SET
SET
Fig 3
LED power indicator
LED Speed indicator
Speed UP
Speed Down
Turn the FanOFF
Forward/Reverse
Light ON/OFF
Button Definition
Fig 4
Fig 5
On
Off
On
Off
Publicidad
