Yamaha DPX-1000 Manual De Instrucciones página 8

I Using the remote control
Use the remote control under the following conditions. The remote control will not function if it is used outside the angles and/or range
detailed here.
Usable distance
7 m (23 feet)
A left/right arc of 30 degrees
7 m
(23 feet)
AUTO
V. POS ZOOM FOCUS
IRIS SETTING PATT
ESCAPE MENU
ASPECT INPUT
LIGHT
STILL HIDE
INPUT
S VIDEO A DVI
VIDEO B D4
MEMORY
1 2 3
4 5 6
RESET
Important
• Bright light, fluorescent light etc. on the remote sensor on the main unit may inhibit the normal functioning of the remote control.
• The remote may not function normally if there is an obstacle blocking the signal between the remote and the remote control sensor
on the main unit.
• The above are approximate figures.
I Loading the batteries into the remote
control
1.
Remove the battery compartment cover from the
back of the remote control.
2.
Insert two batteries (AA, UM3, or R6 type), matching
the polarity markings (+, –) on the batteries with
those in the battery compartment.
3.
After inserting the batteries, close the cover until it
snaps into place.
Important
• If the remote must be used closer to the main unit than
normal, or does not always operate correctly, exchange the
batteries for new ones.
• Do not mix old and new, or different types of battery.
• Remove the batteries if you do not plan to use the unit for a
long time.
• If the batteries leak, dispose of them immediately, taking care
not to touch the battery fluid. If the battery fluid comes into
contact with your eyes, mouth, or skin, rinse it off with water
immediately and consult a doctor. Clean the battery
compartment thoroughly before installing new batteries.
Usable angle
30 degrees
A vertical arc of 30 degrees
OUT IN
DVI REMOTE RS-232C TRIGGER OUT
INPUT B INPUT A
RGB/YP P B /YC R B R C D4 VIDEO G/Y B/P B B /C R/P R /C R HD/SYNC VD S-VIDEO VIDEO
AUTO
V. POS ZOOM FOCUS
IRIS SETTING PATT
ESCAPE MENU
ASPECT INPUT
LIGHT
STILL HIDE
INPUT
S VIDEO A DVI
VIDEO B D4
MEMORY
1 2 3
4 5 6
RESET
I Using the remote as a wired remote
To use the remote control as a wired remote control, use a 2P
monaural miniplug to connect the remote control cable jack on the
underside of the remote control to the REMOTE IN jack on the
main unit.
Part Names and Functions
7 m (23 feet)
7 m (23 feet)
control
DVI
INPUT B INPUT A
RGB/YP B P R /YC B C R D4 VIDEO G/Y B/P B /C B R/P R /C R HD/SYNC
-2
ID
-1
ID
OUT IN
REMOTE RS-232C TRIGGER OUT
VD S-VIDEO VIDEO
5
E-