Onkyo TX-8260 Manual De Instrucciones página 33

> Before Start > Part Names
BT Wakeup This function wakes up the unit on standby by connecting a
BLUETOOTH wireless technology enabled device.
"On": When this function is to be used
"Off (default value)": When this function is not to be used
0 When this setting is turned "On", power consumption
increases even when this unit is on standby, however, the
increase in power consumption is kept to a minimum by
automatically entering the HYBRID STANDBY mode, where
only essential circuits are operating.
0 The setting is fixed to "Off" if "7. Bluetooth" - "AutoChange" is
set to "Off".
Opt1Wkup When an audio signal is input through the OPTICAL 1 terminal
while this unit is in standby, this feature automatically detects it.
"Main": This unit is turned on and outputs the audio in the main
room.
"Zone2": ZONE 2 is turned on and outputs the audio in the
separate room.
"Both": This unit is turned on, ZONE 2 is turned on, and audio is
output in both the main room and in the separate room.
"Off (default value)": The function is disabled.
0 When a cable is connected to the OPTICAL 1 terminal and
this setting is enabled, power consumption increases even
when the unit is on standby, however, the increase in power
consumption is kept to a minimum by automatically entering
the HYBRID STANDBY mode, where only essential circuits
are operating.
0 "The Opt1Wkup feature does not work when the unit is in the
mode for controlling ZONE 2 (P27).
AM/FM Select a frequency step depending on your area of residence.
Select "9k/0.05M" or "10k/0.2M (default value)".
0 When this setting is changed, all radio presets are deleted.
> Install > Initial Setup > Playback
Supplementary information |
4. Source
Intelli Adjust the volume level difference between the devices
connected to the unit. Select the input selector to configure.
Select from "-12 dB" to "+12 dB". Set a negative (j) value if the
volume of the target device is larger than the others and a
positive (i) value if smaller. To check the audio, start playback of
the connected device. (Default Value is "0 dB")
0 This function is not effective in ZONE 2.
Name Edit Set an easy name to each input. The set name will be shown on
the main unit display. Select the input selector to configure.
For details on how to enter text, refer to "Entering text" (P15).
0 To name a preset radio station, press TUNER on the remote
controller, select AM/FM and select the preset number.
0 It cannot be set if the "NET" or "BLUETOOTH" input is
selected.
5. Zone2
Z2Out If the amplifier you connected for the multi-room feature doesn't
enable you to adjust the volume, you can adjust the volume,
balance, bass, and treble for ZONE 2 on this unit.
"Fixed": (default value): Adjust the volume and sound quality on
the amplifier for ZONE 2.
"Variable": You can adjust the volume and sound quality on this
unit.
Z2MaxVol Set the maximum volume for the volume control of ZONE 2.
Select "Off (default value)" or a value between "50" to "99".
0 You can set this only when "Z2Out" is set to "Variable".
Z2POnVl Set the volume for when the unit of ZONE 2 is turned on. Select
"Last (default value)" (volume level before entering standby
mode), "Min", "0.5" to "99.5" and "Max".
0 You can set this only when "Z2Out" is set to "Variable".
6. Network
0 When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the setting
automatically. Further, to assign fixed IP addresses to each component, you must set
Advanced Setup | Others
En 33