Troubleshooting - Silverline 246525 Manual De Uso

GB

Troubleshooting

Problem
Red LED does not illuminate and
Battery (9) not charging
Battery has low capacity
Drill cannot be switched on (Trigger
Switch (6) does not move)
Drill does not start when Trigger
Switch is pressed
Screws do not reach deep enough
into the workpiece
Screws are driven too deep into the
workpiece surface
8
Possible cause
Battery not fully seated
Charger (12) not powered
Battery not being fully charged
Battery charged days before use
Battery has been charged over 100 times and capacity has
started to reduce
The Forward/Reverse Switch (5) may be in the middle
("locked") position
Battery completely discharged
Defective Battery
Drill machine defective
Not enough torque; Torque Selector (3) setting too low
Low battery voltage
Too much torque; Torque Selector (3) setting too high
Solution
Clean Battery Connector (10) socket
Recheck mains connection
Increase speed
Change blade
This is normal for batteries. Contact your Silverline dealer to purchase a replacement
battery
Slide the Forward/Reverse Switch either to the left or right
Recharge Battery or replace with a fully charged battery
Replace Battery
Contact your Silverline dealer or authorised service centre
Choose a higher torque setting
Recharge Battery or replace with a fully charged battery
Choose a lower torque setting