Troubleshooting - Silverline 975325 Manual De Instrucciones

Troubleshooting

Problem
Red LED (19) does not illuminate and Battery (12) not charging
Battery has low capacity
Drill cannot be switched 'ON' (ON/OFF Trigger Switch (15) does
not move)
Drill does not start when ON/OFF Trigger Switch is pressed
Screws do not reach deep enough into the workpiece
Screws are driven too deep into the workpiece surface
Possible cause
Battery not fully seated
Battery Charger (16) not powered
Battery not being fully charged
Battery has been charged over 300 times and capacity has
started to reduce
The Forward/Reverse Switch (8) may be in the middle
("locked") position
Battery completely discharged
Defective Battery
Drill defective
Not enough torque; Torque Selector (3) setting too low
Low battery voltage
Too much torque; Torque Selector (3) setting too high
18V Drill Driver
Solution
Clean Battery and Battery Charger contacts
Recheck mains connection
Charge the Battery until Red LED is extinguished
This is normal for batteries. Contact your Silverline dealer to
purchase a replacement battery
Slide the Forward/Reverse Switch either to the left or right
Recharge Battery or replace with a fully charged battery
Replace Battery
Contact your Silverline dealer or authorised service centre
Choose a higher torque setting
Recharge Battery or replace with a fully charged battery
Choose a lower torque setting
silverlinetools.com
9