Safety Instructions - Ferm MSM1037 Manual De Uso

Features
Figs. 1, 2, 3, 4 and 5
1. On/off switch
2. On/off switch for laser
3. Unlock button (Blade protective cover)
4. Cover carbon brush
5. Lock-pin
6. Blade protective cover
7. Workpiece clamp
8. Guide fence
9. Knob adjusting saw angle
10. Locking knob
11. Laser battery
12. Sliding fence knob
13. Connection dust bag
14. Bevel angle
15. Handle
16. Cover
17. Saw blade bolt
18. Flange
19. Screw
20. Retraction arm
21. Extension pieces (left and right)
22. Lock-button saw blade
23. Angle indicator
24. Support bracket

2. SAFETY INSTRUCTIONS

By using electric tools basic safety precautions
should always be followed to reduce the risk of
fire. Electrical shock and personal injury.
Always read the specific product instruction manual
and the safety instructions before attempting to
operate the power tool and store these instructions.
Install of a stationary machine
Fig. 6
This machine is a stationary machine and for
safety reasons must always be firmly installed and
not used for mobile applications.
You can install the machine in two ways:
a) As a stationary machine on a workbench.
In case the machine must be secured to the
workbench with 4 bolts.
b) As a stationary machine on a sub frame. In this
case the machine must be secured to the sub
frame with 4 bolts and the sub frame anchored
with 4 bolts to the floor plate with dimensions
of at least 1 square meter.
6
Symbols
The following symbols are important for the
operations of your power tool. The correct
interpretations of the symbols helps you operate
the power tool more save.
Denotes risk of personal injury, loss of life
or damage to the tool in case of
nonobservance of the instruction in this
manual.
Caution, risk of electric shock.
Keep bystanders away.
Wear eye protection.
Wear ear protectors. Exposure to noise
can cause hearing loss.
Wear a dust mask.
Danger Area! Keep hands far away
(10cm) from the cutting area while the
machine is running. Danger of injury
when coming in conatct with the saw
blade.
Do not direct the laser beam at persons
or animals and do not stare into the laser
beam yourself, not even from a distance.
This power tool produced laser class 2
laser radiation according to EN 60825­1.
This lead can lead to person being
blinded.
Disc dimensions. Observe the
dimensions of the saw blade. The hole
diameter must match the tool spindle
without play. *Use only a fill ring which is
specified by supplier, filling ring may not
have any play.
Tranport the machine only when the
machine is in inward transport position.