Work Safety - Husqvarna DC 5500 Manual De Instrucciones

Always use common sense
It is not possible to cover every conceivable situation you can
face. Always exercise care and use your common sense. If
you get into a situation where you feel unsafe, stop and seek
expert advice. Contact your dealer, service agent or an
experienced user. Do not attempt any task that you feel
unsure of!

Work safety

Work area safety
• Do not use the machine in bad weather, such as dense
fog, heavy rain, strong wind, intense cold, etc.
• Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
• The machine should not be used in areas where potential
for fire or explosions exist.
Electrical safety
WARNING! There is always a risk of shocks
!
from electrically powered machines. Avoid
unfavourable weather conditions and body
contact with lightning conductors and metal
objects. Always follow the instructions in the
Operator's manual to avoid damage.
Never connect the machine to a outlet if plug
or cord is damaged.
• Check that the mains voltage corresponds with that stated
on the rating plate on the machine.
• Inspection and/or maintenance should be carried out with
the motor switched off and the plug disconnected.
• Always shut down the machine before disconnecting the
power plug.
• Always unplug the machine during longer work breaks.
• Never drag the machine by means of the cord and never
pull out the plug by pulling the cord. Hold the plug to
disconnect the power cord.
• Never use the machine if any cable or plug is damaged,
but hand it in to an authorized service workshop for repair.
• The machine must never be driven to such a depth in
water that it reaches up to the machine's equipment. The
equipment can be damaged and the machine can be live,
resulting in personal injuries.
8 –
English
OPERATING
Grounding instructions
!
• The machine is equipped with a grounded cord and plug
and should always be connected to a grounded outlet.
This reduces the risk of electric shock in the event of
malfunction.
• The use of adaptors is not allowed with the machine.
Extension cords and cables
• The marking on the extension cable must be the same or
higher than the value stated on the machine's rating plate.
• Use grounded extension cables.
• When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of a cord
suitable for outdoor use reduces the risk of electric shock.
• Keep the connection to the extension cord dry and off the
ground.
• Keep cable away from heat, oil, charp edges or moving
parts. Damaged or entangled cable increase the risk of
electric shock.
• Check that the cables are intact and in good condition.
Never use the machine if any cable or plug is damaged,
but hand it in to an authorized service workshop for repair.
• To avoid overheating do not use the extension cord while
it is rolled up.
• Ensure the cord is behind you when you start to use the
machine so that the cord will not be damaged.
Personal safety
• Wear personal protective equipment. See instructions
under the heading "Personal protective equipment".
• Never use the machine if you are tired, if you have drunk
alcohol, or if you are taking medication that could affect
your vision, your judgement or your co-ordination.
• Never allow anyone else to use the machine without first
ensuring that they have understood the contents of the
operator's manual.
• All operators shall be trained in the use of the machine.
The owner is responsible for ensuring that the operators
receive training.
• People and animals can distract you causing you to lose
control of the machine. For this reason, always remain
concentrated and focused on the task. Never allow
children to use or be in the vicinity of the machine.
• Be careful as clothing, long hair, and jewellery can get
caught in moving parts.
WARNING! Improper connection can result
in the risk of electric shock. Contact a
qualified electrician if in doubt as to whether
the appliance is properly grounded.
Do not modify the plug. If it will not fit the
outlet have a proper outlet installed by a
qualified electrician. Make sure local
regulations and ordinances are followed.
If the grounding instructions are not fully
understood contact a qualified electrician.