Publicidad
Idiomas disponibles
Idiomas disponibles
6
GETTING STARTED
Fill
ON
OFF
Eject
ON
ON
Power
ON
OFF
OFF
ON
High
OFF
Water
ON
Floss
Massage
Low
ON
OFF
Water
ON
Powering the Unit
Plug the cord into an electrical outlet.
Preparing the Reservoir
Lift the reservoir lid, remove the reservoir, and fill with lukewarm water. Replace the
reservoir over the base and press down firmly and close the lid.
Inserting and Removing Tips
Insert tip into the center of the Water Flosser handle, pressing down firmly until the
tip clicks into place. The colored ring will be flush with the top of the handle if
the tip is correctly locked into place. To remove tip from the handle push the tip
eject button on the handle.
Prime Unit (First Time Use Only)
Set pressure control dial on base to pressure setting No.10, point the handle and tip
into sink. Turn power and water ON until water flows from the tip. Turn Power OFF.
Adjusting the Pressure Setting
Turn the pressure control dial on the base of the unit to the lowest setting for
first-time use. Gradually increase pressure over time to the setting you prefer
– or as instructed by your dental professional.
Using the Water Flosser
Always place the tip in your mouth before turning the water ON. Turn power
on, lean over sink and slightly close lips enough to prevent splashing while
still allowing water to flow from mouth into the sink. Turn water switch ON.
When finished, turn water switch and power OFF. During use you can stop the
flow of water by sliding the water switch on handle to the OFF position.
NOTE: Motor will continue to run.
For best results, start with back teeth and work toward the front teeth. Direct
the stream at a 90-degree angle to your gumline with tip in mouth. Glide tip along
gumline and pause briefly between teeth. Continue until you have cleaned the inside
and outside of both the upper and lower teeth.
Publicidad
