Bosch MUM58 Serie Instrucciones De Uso página 22

en Operation
Important information concerning the
use of the whisk (Figure E):
The whisk should almost touch the bottom
of the bowl to ensure that the ingredients
are optimally mixed. If not, adjust the height
of the whisk as follows:
■ Remove mains plug.
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the whisk into the drive
until the whisk locks into position.
■ Hold whisk in place and loosen nut clock­
wise using open­ended wrench (size 8).
■ Set the whisk to the optimum height by
rotating the whisk:
– Turn clockwise: Raise
– Turn anti­clockwise: Lower
■ Press the Release button and
move the swivel arm to
position 1.
■ Check the height of the whisk
and, if required, correct.
■ When the height has been set
correctly, press Release button
and move the swivel arm to
position 2.
■ Hold whisk in place and tighten nut
anticlockwise using open­ended wrench
(size 8).
Working with the bowl and the tools
Fig. F:
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the bowl:
Tilt the bowl forwards and then set it
down. Turn anti­clockwise until it locks
into place.
■ Depending on the processing task, insert
the stirrer, whisk or kneading hook until it
locks into position.
Note:
If using the kneading hook, rotate the dough
deflector until the kneading hook can lock
into position (Fig. F-4b).
■ Put the ingredients to be processed into
the bowl.
22
■ Press the Release button and move the
swivel arm to position 1.
■ Attach the cover.
■ Set the rotary switch to the desired
setting.
Our recommendation:
– Professional flexi stirring whisk:
First mix at setting 1­2, then setting
3­5 as required
– Professional beating whisk:
setting 7, mix in at setting 1
– Kneading hook:
first stir in at setting 1, knead at setting 3
Adding more ingredients
■ Switch off the appliance with the rotary
switch.
■ Add more ingredients through the feed
tube in the cover.
or
■ Remove lid.
■ Press the Release button and
move the swivel arm to
position 2.
■ Add ingredients.
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Remove mains plug.
■ Remove lid.
■ Press the Release button and
move the swivel arm to
position 2.
■ Take the tool out of the drive.
■ Remove the bowl.
■ Clean all parts, see "Cleaning and
servicing".
Continuous-feed shredder
W Risk of injury
Do not grip the sharp blades or edges of the
cutting discs. Take hold of cutting discs by
the edge only. Before attaching / removing
the continuousfeed shredder, wait until the
drive has come to a standstill and pull out
the mains plug. Do not reach into the feed
tube.