Bosch 800 Serie Instrucciones De Uso página 26

en
Problem
Water droplets are
forming inside the
appliance.
Drawers can only be
closed with great
difficulty.
Ice and water dispenser
Problem
The water filter symbol is
flashing.
The ice maker is not
making enough ice
cubes or the ice cubes
are deformed.
The ice maker is not
making enough ice
cubes or any ice cubes
at all.
The ice cube container
contains ice cubes that
are not being
dispensed.
The ice maker is not
making ice cubes.
26
Possible cause
Humidity is too high or doors have been
opened frequently.
The door seals are not tight.
The drawer has not been inserted correctly.
The drawer rails are dirty.
Possible cause
The filter cartridge is old.
After replacing the filter cartridge, the water
filter symbol was not reset.
The appliance or ice maker was just recently
switched on.
A large amount of ice has been taken out.
Water pressure is too low.
The filter cartridge is clogged or old.
An ice cube is jammed on the arm that
measures the level of the ice cube container.
When switching from ice cubes to crushed
ice , an ice cube may become jammed inside
the dispenser opening. The ice cube will
begin to melt and water will drip into the ice
and water dispenser.
There is a layer of ice on the screw conveyor.
Ice cubes are frozen to one another.
The ice maker is switched off.
The appliance is not being supplied with
water.
The water connection line has kinks in it.
Water pressure is too low.
The ice cube container is not inserted
correctly.
The water connection is installed incorrectly.
Corrective action
Do not open doors as frequently or do not keep
them open too long.
Check the door seals and foldaway door bar; if
necessary, clean or correct position.
Insert the drawer correctly.
Clean the drawer rails.
Corrective action
Replace the filter cartridge.
Reset the water filter symbol.
It takes approx. 24 hours before it starts making
ice.
It takes approx. 24 hours before the ice storage
bin is full again.
Have the water pressure checked.
Replace the filter cartridge.
Remove the ice cube container and release the
jammed ice cubes with a blunt plastic tool. Do not
use sharp or pointy objects as this could damage
the appliance.
Release the jammed ice cube from the dispenser
opening using a blunt plastic tool. Do not use
sharp or pointy objects as this could damage the
appliance.
Remove and clean the ice cube container.
Remove and clean the ice cube container.
Switch on the ice maker.
Have a qualified technician check the water
connection.
Shut off the water supply. Straighten out the
kinks. Have damaged water connection lines
replaced with original manufacturer parts.
Have the water pressure checked.
Insert the ice cube container correctly.
If the water connection is not installed correctly,
this can cause low water pressure and can
damage the appliance.