Installation - Bosch 800 Serie Instrucciones De Uso

en

Installation

Transport and installation
The appliance is heavy and must be
secured during transport and
installation.
WARNING
Risk of injury!
The appliance is very heavy. It can
fall over and cause serious injuries
during transport and installation.
At least two people are required to
install the appliance safely. Keep
the refrigerator doors closed until
the appliance is upright and level
at the installation location.
Installation location
WARNING
Risk of explosion!
Do not install the appliance near
explosive or flammable
substances.
NOTICE
Do not install the appliance outdoors.
The installation location should be
dry and should not be exposed to
frost.
The best installation location is a dry,
well ventilated room. The installation
location should neither be exposed to
direct sunlight nor should it be near a
heat source, such as a stove, radiator,
etc. If installation next to a heat source
is unavoidable, use a suitable
insulating plate or observe the
following minimum distances to the
heat source:
1/4 I
S 1 (3 cm) to electric or gas
stoves.
3/16 I
S 11 (30 cm) to oil or solid fuel
stoves.
If installing the refrigerator next to
another refrigerator/freezer, there must
be a minimum clearance of 1" (25 mm)
between the appliances to prevent
condensation.
6
If a panel or cupboard is installed
above the appliance, ensure to leave a
I
13/32 (10 mm) gap so that the
appliance can be pulled out of the
recess if required.
The air heated at the back of the
appliance must be allowed to escape
unhindered.
To ensure that the doors can open all
the way, maintain the lateral minimum
clearances when installing the
appliance in a corner or recess (see
section on "Appliance and installation
dimensions").
If the depth of the adjacent kitchen
1/8 I
equipment exceeds 29
maintain the minimum lateral
clearances in order to utilize the full
door opening angle (see section "Door
opening angle").
Subsurface
NOTICE
The appliance is very heavy.
The floor on which the appliance is
to be installed must be rigid.
Reinforce the floor, if necessary.
Weight of appliance when empty:
Basic model 324 lb (147 kg)
Ventilation
Never cover the ventilation openings
on the front base panel or rear cover
plate.
(75 cm),
This forces the appliance to work
harder, increasing its power
consumption.