Transportation, Storage And Disposal; To Safely Attach The Product On A Trailer For Transport - Husqvarna RC 318T Manual De Usuario

Problem
The battery does not charge
There is vibration in the product
The mowing result is unsatisfac-
tory
Transportation
• The product is heavy and can cause crush injuries.
Be careful when you load it onto or off a vehicle or
trailer.
• Use an approved trailer for transportation of the
product.
• Make sure that you have knowledge of local road
traffic regulations before transportation of the
product in a trailer or on roads.
To safely attach the product on a trailer for
transport
WARNING: The parking brake is not
sufficient to lock the product during
63 - 007 - 20.06.2017
Cause
The battery is defective. See
The connection at the cable connectors on the battery terminals is bad. See
tery safety on page 11 .
The battery is in protective mode. See
The collector is full. The operator has ignored the collector full signal or the sen-
sor for collector full is set in the incorrect position. See
collector full on page 15 .
The product is operated in long, thick and/or wet grass in non-collect mode. See
To get a good mowing result on page 18 .
The blades are loose. See
One or more of the blades are unbalanced. See
27 .
The auger is damaged.
The engine is loose.
The blades are blunt. See
The grass is long or wet. See
The cutting deck is skew.
There is grass blockage in the cutting deck. See
20 .
The tire pressure is different on the right and left sides. See
sure on page 24 .
The product is operated at a too high speed. See
on page 18 .
The engine speed is too low. See
The drive belt slips.

Transportation, storage and disposal

Battery safety on page 11 .
To charge the battery on page 24 .
To examine the blades on page 27 .
To examine the blades on page
To replace the blades on page 27 .
To get a good mowing result on page 18 .
To get a good mowing result on page 18 .
transport. Attach the product tightly to the
trailer.
Equipment: 2 approved tension belts and 4 wedge
shaped wheel blocks.
1. Apply the parking brake.
2. Attach the tension belts around the frame or rear
wagon.
3. Tighten the tension belts in the direction of the rear
and the front of the trailer to secure the product.
4. Put the wheel blocks in front of and behind the rear
wheels.
To adjust the sensor for
To clean the product on page
To set the tire pres-
To get a good mowing result
Bat-
31