Stop Switch; Muffler - Husqvarna T435 Manual De Instrucciones

Stop switch

Start the engine and make sure the engine stops when
you move the stop switch to the stop setting.
Muffler
Never use a machine that has a faulty muffler.
Regularly check that the muffler is securely attached to
the machine.
Loosen the screws (1 and 2).
MAINTENANCE
Push the muffler cover as shown in the picture.
Loosen the screws and nuts. Remove and check that the
muffler is ok.
The muffler is designed to reduce the noise level and to
direct the exhaust gases away from the operator. The
exhaust gases are hot and can contain sparks, which may
cause fire if directed against dry and combustible
material.
The muffler is equipped with a special spark arrestor
mesh. The spark arrestor mesh should be cleaned once a
month. This is best done with a wire brush. A blocked
mesh will cause the engine to overheat and may lead to
serious damage.
Note! The mesh must be replaced if it is damaged. If the
mesh is blocked the machine will overheat and this will
cause damage to the cylinder and piston. Never use a
machine with a muffler that is in poor condition. Never
use a muffler if the spark arrestor mesh is missing or
defective.
–
English 33