Other Convenient Features; Demonstration Mode; Monitor; Care And Cleaning - Sharp R-CD1200M Manual De Operación

OTHER CONVENIENT FEATURES

Demonstration Mode

To demonstrate, press the SELECT TIME pad, 0 and then
press the START pad and hold for 3 seconds. Cooking
operations can now be demonstrated with no power in
the oven. The timer will count down rapidly.
To cancel, press the SELECT TIME pad, then 0 and the
STOP/ CLEAR pad or unplug your oven.
To set cooking during the Demonstration Mode, press the
SELECT TIME pad and enter time and press the START
pad. After cooking, press the STOP/CLEAR pad to show
Demonstration again.

CARE AND CLEANING

VERY IMPORTANT CAUTIONS
* DO NOT OPERATE your oven without the oven ceiling cover or the splash cover in place.
* DO NOT REMOVE the antenna cover. It is not designed to be removable.
* DO NOT REMOVE the ceramic shelf from the oven. It is not designed to be removable.
* DO NOT OPERATE the oven without the air intake fi lter in place.
* DO NOT USE commercial oven cleaners, abrasive or harsh cleaners or scouring pads on any part of your
microwave oven.
Tab
Knob
Splash Cover
Oven Ceiling Cover
Fig.1
Fig.3
Oven Exterior
The outside of your oven can be easily cleaned with mild
soap and water. Make sure to rinse thoroughly and dry
the exterior with a soft towel.
Control Panels
Care should be taken in cleaning the control panels.
Open the door before cleaning to inactivate the control
Tab
Ceramic Shelf
Projection B
Catch
Fig.4

Monitor

Monitor function is used to check the power level during
cooking.
To check the power level, press the SELECT POWER
pad and the power level will be displayed. As long as
the SELECT POWER pad is pressed, the power level is
displayed. When the SELECT POWER pad is released,
the display will return to the previous display.
Splash Cover
Projection
Pin
Knob
Hole
Frame
Cover
Fig.5 Oven Ceiling Cover
panel pads. Using a cloth dampened with water only,
gently wipe the panels until clean. Avoid the use of
excess water. Do not use chemical or abrasive cleaners
because they may cause severe damage to the panels
and make programming impossible.
EN-23
Oven Ceiling Cover
Projection A
Hole
Hole
Antenna Cover
Hole
Screw
Air intake fi lter
Fig.2
Projection A
Catch
Fig.6