seT up
If water has been spilled onto the cradle or it has been submerged into water, unplug the power cord from the power
source immediately. Allow the device to completely dry before use.
If the device has been dropped, refer to the troubleshooting guide for instructions. contact your homecare provider for
evaluation of the device.
Never block the air openings of the cradle or chamber. Do not insert any objects into any openings or tubes.
For proper operation of the humidifier, the device must be placed on a flat, level surface.
Never place the system on a soft surface such as a bed or couch during operation.
this heated humidifier is intended for single-patient use only.
Be sure that you read and understand the information in this instruction guide. By following these instructions and the
advice of your physician, your heated humidifier system will become an effective addition to your cPAP therapy.
Empty and dry the water chamber before transporting.
cAutION– The height of the system must always be lower than the interface mask during use to prevent water from getting into the CPAP mask.
SET UP
unpacking the contents
The following items are included in your Heated Humidifier system:
1.
Humidifier Cradle with Water Chamber (Figure A)
2.
User Manual
NOtE-
Please contact your home care provider if any of the above items are missing.
Important Parts Of Your Integrated Humidifier/Heater
Humidifier cradle (Figure B)
1.
Heater plate
2.
Heater power connector
3.
Storage compartment for heater power connector soft cover (on bottom)
4.
Air supply port inlet
5.
Air supply port outlet
6.
Flow generator release button
7.
Flow generator locking tabs
Water chamber (Figure c)
1.
Chamber lid
2.
Chamber base
3.
Heat transfer plate (on bottom)
4.
Sealing gasket
5.
Water level indicators (front and sides)
6.
Chamber release latch
7.
Chamber disassembly lever
EN
A
5
3
B
(bottom)
6
2
4
1
7
c
7
6
4
1
2
5
3
(bottom)
A-DV5HH
5