Operatingp Ressure - Craftsman 351.184090 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING
P RESSURE
o
Use only enough air pressure to perform the operation. Air
pressure in excess of that which is required will make the
operation inefficient and may cause premature wear or
damage to the tool.
o
Determine minimum air pressure required by driving some
test fasteners into the workpiece. Set air pressure so that
test fasteners are driven down flush with the work surface.
Fasteners driven too deep may damage workpiece.
EXHAUST
DEFLECTOR
Refer to Figures 4 & 5 (pages 4 and 6).
o
Exhaust deflector can be positioned to point in any direc-
tion (full 360 ° movement). Reposition deflector (Fig. 5, No.
2) by grasping firmly and rotating to the desired position.
Figure 4 - Exhaust Deflector Adjustment
Refer to Figure 5 (page 6).
MAGAZINE
AND PISTON-RAM
°
Keep magazine and nose of tool clean and free of any dirt,
lint or abrasive particles.
The tip of the ram (Fig. 5, No. 18) can become dented or
rounded over time.
Square off the tip of the ram with a clean, fine hand file to
extend the life of the ram and tool. Fastener firing will be
more consistent if the ram tip is kept clean and square.
SAFETY
MECHANISM
Inspect contact trip safety mechanism daily for proper opera-
tion. Do not operate tool if mechanism is not operating
properly.
With the red push-button switch in the rapid-fire mode, per-
form the following procedures to test safety mechanism:
Leave trigger untouched while pushing contact trip into
workpiece. Tool must not fire.
Pull trigger while contact trip is clear of work and pointed
away from operator and others. Tool must not fire.
Depress and hold trigger. Push contact trip against work
where fastener is needed. The tool should drive only one
fastener each time the contact trip is pushed against
workpiece.
If contact trip mechanism
does not operate properly,
repair tool immediately
through
Sears Service Center.
Replace any damaged or missing parts. Use the parts list to
order parts.
REBUILD
KITS
Rebuild kits are available as spare parts, (see page 7). Tools
should be rebuilt if tool fails to operate properly after extended
use. See troubleshooting to determine required replacement
parts.
Disconnect
tool from air supply before attempting
repair
or adjustment.
NOTE: When replacing O-rings or cylinder, lubricate with air
tool oil before assembly.
4

Publicidad

Tabla de contenido
loading

Tabla de contenido