Atmor Supreme InLine AT-S901-03 Guía De Instalación Y Funcionamiento página 4

Assembly Instructions
01
Connect the Pressure Relief
Device (PRD) to the unit (Fig1)
Note: IMPORTANT – do not
discard this step. A PRD
04
must be installed.
1. Mount ground plate to wall.
2. Pull wires through.
(Figure 4)
05
Connect the water inlet hose to the entry point of the heater (left side
inlet), and connect the outlet hose to the water outlet. Use a hose that
can withstand a minimum pressure of 4 bars. Using any other type of
hose will cause damage (Figure 5).
Residential plumbing systems with unstable pressure or pressure
above 5 bar require the application of a pressure stabilizer valve, set
06
to 4 – 5 bars.
Do not install the appliance with water inlets and outlets at the
top (Figure 7)
3
02
Remove the appliance
covers (Figure 2).
03
Mount unit to wall with
4 screws at the marked
points (Figure 3)
The appliance must be
mounted horizontally,
with water inlets and
outlets at the bottom
(Figure 6)