Atmor Supreme InLine AT-S901-03 Guía De Instalación Y Funcionamiento página 6

07
Run the water flow for
one minute to check for
leakage before connecting
to power.
09
Remove the cable entry cover from the
side entry cable (right or left) figure 5.
Reattach the front cover of the heater
and secure it with 4 screws.
11
When installed outdoors,
the heater must be
placed in sealed
waterproof electrical box.
14
Aerator provided with 3kW models only
Assembly instructions
For optimal heating performance and proper
operation, the provided 0.5GPM aerator must
be installed to your sink faucet. This will ensure
a continuous flow and consistent, maximum
temperature rise. Output temperature will vary
depending on seasonality and inlet cold water
temperatures
Maximum of 0.5 GPM flow rate is needed for
optimal heating performance
5
08
Connect the power cable to the
terminal block.
Caution: The heater must be
grounded.
Reference figure *4 on page 4 and
Electrical diagram on page 6
12
Do not install the heater
where it may be subject to
direct sunlight.
10
Make sure that the
appliance is filled with
water before connecting
power. (Repeat step 7)
13
It is recommended that
the appliance electrical
connections be tested
once a year by a qualified
technician.