Troubleshooting - Carson SA315 B Lama Manual De Instrucciones

j. Troubleshooting
GB
Please read this before something happens.
Problem
The model does not
move
Motor does not turn
The model reacts
incorrectly to the control
commands or flies
choppily
The model does not
take off
The rotors do not allow
shut down
The model moves
forwards/backward and
sidewise, but does not
hover
The model vibrates
severely
The tail does not permit
stabilizing
22 CARSON SA315 B Lama 1:16
Cause
1. Check whether the transmitter and the receiver
are switched on
2. Check the battery voltage of transmitter and
receiver
3. The trim slider of the pitch-function stands on the
upper stop
1. Motor is defective
2. Motor is too hot
1. Check the state of the transmitter and receiver
battery charges
2. Receiver antenna still wound up
1. Rotor blades are twisted
2. Motor is too hot
3. Batteries are empty
Trim is not correctly adjusted
Check whether the helicopter is exposed to a draught,
e.g. by an opened window or an air conditioner. Hover
flight is not possible when there is a draught
1. Check whether the principal rotors run true
2. Check whether the model is correctly balanced
1. One or more rotor blades are defective
2. Lower and upper rotor revolution run with different
friction on the rotor shaft
3. The velocity of rotation of the upper and lower rotor
revolution is uneven
Reparation
Switch transmitter and/or receiver on
Employ completely charged batteries
Ensure that the trim slider of the pitch
function is in neutral position or somewhat
below
Exchange the motor
Allow the motor to cool down
Employ completely charged batteries
Unwind the receiver antenna completely
Exchange the rotor blades
Allow the motor to cool down
Charge the batteries or exchange them
Correct the trim on the pitch controller
Close the window/door, switch off the air
conditioner or select a more suitable room
Possibly change the rotor blades
Possibly change the rotor blades
Replace one or both rotor blades
Ensure that both rotor revolutions allow for
easy rotation
Correct the trim on the transmitter