Spo 2 Measurement - Gima 32597 Manual Del Usuario

57
 When monitoring the ECG, the electrodes must be assured to connect
with the body thoroughly and stably.

5.1.3 SpO 2 Measurement

1) Insert the oximeter probe to the USB socket. Long press to enter
the SpO monitor interface automatically.
2
2) Put the finger into the oximeter probe monitor as Fig. 5-2.
3) Press long to turn off the device after measuring.
Fig. 5-2 SpO monitor interface
2
Warning: The probe is limited to be collocated by our company, never
replace it with the similar types.
Attention:
 The fingernails of the testee should not be too long.
 Testee can not use enamel or other makeup.
 As to the fingers which are too thin or too cold, it would probably affect
the normal measure value,please clip the thick finger such as thumb
and middle finger deeply enough into the probe.
 Do not shake the finger and keep the patient in a stable state during using
process.
 Fingernails and the luminescent tube should be on the same side.
 Excessive ambient light may affect the measuring result. It includes
fluorescent lamp,dual ruby light, infrared heater,direct sunlight and etc.
 There shouldn't be rubber fabric and so light barrier on the way of light,
or else it may result in inaccurate measure.
 The photoelectric receiving tube of the SpO
tube should be arranged in a way with the subject's arteriole in a position
there between.
 Avoid to use in a location or limb tied with arterial canal or blood
pressure cuff or receiving intravenous injection.
 Strenuous action of the subject or extreme electrosurgical interference
may also affect the accuracy.
 If some abnormal conditions appear on the screen during monitor
process, pull out the finger and reinsert to remeasure.
ENGLISH
sensor and luminescence
2