Electrical Connection - Brandt BFC582LNW Guia De Instalacion

small movements. Do not
move on longer distance.
Make an initial cleaning
·
before connecting
device to the mains. Before
any maintenance,
disconnect your device. Do
not pull the power cord but
directly enter the profile.
Place the unit in a dry and
·
ventilated room.
Avoid balconies, porches,
·
decks; excessive heat in
summer and cold in winter
could prevent
operation of your device, or
even damage.
Do not place it near a heat
·
source such as radiator or
oven for example.
Keep a minimum distance
·
between your refrigerator
and other furniture: 3 to 5
cm on the sides and 10 cm
above for good
circulation around the unit.
Place the appliance at a
·
suitable distance from the
wall using the spacers if they
provided in the accessory
bag.
Your appliance has been
·
designed for
performance in
temperature. We then say
that it is designed for a
special "climate class". This
climate class is clearly stated
on the rating plate located
inside your appliance, on the
left wall down. Beyond these
temperatures,
performance of
appliance may be reduced.
Classe Temperature
SN from + 10°C to + 32°C
N from + 16°C to + 32°C
ST from + 16°C to + 38°C
T from + 16°C to + 43°C
Advice:
After installation of your
appliance, set its feet so that
your
it is slightly tilted backwards,
it will facilitate the closing of
the door.
Before putting food, clean
the interior and exterior of
your
bicarbonate
dissolved
tablespoon of bicarbonate
for 4 litres of water). Do not
proper
use
powders or detergents which
could damage the surfaces.
(See chapter "Cleaning your
appliance").
ELECTRICAL
CONNECTION
The
air
must
applicable
must be able to withstand
the
indicated on the rating plate.
The plug must be properly
grounded.
optimum
a room
We
responsible for any incident
caused by defective electrical
installation.
Electrical
the
Tips
your
• Do not use extension cable
or adapter or power strip.
• Never
grounding.
• The socket must be easily
7
appliance with
of soda
in water
alcohol, abrasive
electrical installation
comply with
standards
maximum power
cannot be held
Installation
remove
(1
the
and
the