Unpacking And First Operation; Unpacking And First Operation Of The Titrator; Connection And Installing Of Piston Burette And Magnetic Stirrer Tm 50 - Xylem SI Analytics TitroLine 5000 Manual De Instrucciones

85

2 Unpacking and First Operation

2.1 Unpacking and First Operation of the titrator

The titrator itself as well as all related accessory and peripheral parts have been carefully checked at
the factory to ensure their correct function and size.
Please ensure that the small accessories are also removed in full from the packaging.
For the scope of delivery, please refer to the enclosed parts list.
The titrator TitroLine® 5000 may be placed on any flat surface.

2.2 Connection and installing of Piston Burette and magnetic stirrer TM 50

The low voltage cable of the power supply TZ 1853 has to be plugged in to the 12 V socket „in"(see
Fig. 3 back panel, chapter. 2.3), on the back panel of the Piston Burette. Then plug the power supply
into the plug socket.
Fig. 1a)
Place the power supply easily accessable in order to be able to remove the Piston Burette anytime
easily from the power circuit.
Insert the stirrer at the lower right side and fasten it by pushing backwards (Fig. 1). This automatically
connects the power supply to the Stirrer TM 50
Fig. 1b) Fig. 2)
The tripod rod TZ 1748 is screwed into the thread and the titration clip Z 305 can now be mounted on
the tripod rod (Fig. 2). Instead of the magnetic stirrer TM 50, you can also install the titration stand
without stirring function TZ3866.