Safety Instructions For Maintenance - Husqvarna FS 500 E Manual De Usuario

Blade guard
WARNING: Do not use the product without a
blade guard or with a defective blade guard.
Make sure that the blade guard is attached
correctly before you start the product.
The blade guard prevent parts, of the blade or the
material that is cut, to be thrown at the operator.
To do a check of the blade guard
• Make sure that the blade guard is correctly installed.
• Make sure that the front nut of the blade guard is
correctly tightened.
• Examine the blade guard for damages, such as
cracks.
• Replace a damaged blade guard.
• Replace the blade guard if it is hit, bent or has other
defects.
Drive belt cover
WARNING: Do not use the product without a
drive belt cover or with a defective drive belt
cover. Make sure that the drive belt cover is
attached correctly before you start the
product.
The drive belt cover gives protection from the pulleys
and the drive belt.
To do a check of the drive belt cover
1. Make sure that the drive belt cover is not damaged
or has cracks. Replace the drive belt cover if it is
necessary.
1024 - 002 - 18.06.2019
2. Make sure that the 3 nuts of the drive belt cover are
correctly tightened.
Error indicator
The error indicator comes on in these situations:
• The motor is to hot: The motor stops.
• The work load is too heavy.
• There is a phase error. It is necessary to adjust the
power plug.

Safety instructions for maintenance

• Keep all parts in good condition and make sure that
all fixtures are correctly tightened.
• Do not use a product that is defective. Do the safety
checks, maintenance and the servicing as given in
this manual. All other maintenance work must be
done by an approved service agent.
49