Connecting The Piston Burette - Combination With Accessories And Additional Devices; Back Panel Of The Titronic ® 500 Piston Burette; Connection Ports Of The Titronic ® 500 Piston Burette; Connecting A Printer - Xylem SI Analytics TITRONIC 500 Manual De Instrucciones

2.4 Connecting the Piston Burette - Combination with Accessories and Additional
Devices
2.4.1 Back panel of the TITRONIC
Fig. 4
2.4.2 Connection ports of the TITRONIC
®
The TITRONIC 500 is equipped with the following connections:
1) USB-B interface for connection to a PC
2) On/Off switch
3) Two USB-A („Master") interfaces for connecting USB devices such as a keyboard, printer, manual control
unit, USB memory stick etc
4) "in": Connection of the external power pack
5) "out": Connection of the TM 235 magnetic stirrer
6) Two RS232 interfaces, 4-channel (Mini-DIN):
RS1 for connection to the PC
RS2 for connection of a weighing balance and other devices from von SI Analytics (burettes, sample
changers)
2.4.3

Connecting a printer

Printers with a USB interface are to be connected to one of the two USB-A interfaces. These printers have to
feature HP PCL emulation (3, 3GUI, 3 enhanced, 5, 5e). So-called GDI printers cannot be used!
2.4.4

Connecting a USB device (manual controller, keyboard, memory device, hub)

The following USB devices can be connected to the USB-A interfaces:
• PC-keyboard
• TZ 3880 manual controller (in the following: "mouse")
• Printer
• USB storage devices, e.g. USB sticks
• USB hub
• USB barcode scanners
2.4.5

Connection of analytical balances

Analytical balances are to be connected to the RS232-2 using an appropriate cable.
Chapter 2 - Unpacking and first Operation
®
500 piston burette
®
500 piston burette
65
1
2
3
4
5
6