Dea NET24N Instrucciones De Uso Y Advertencias página 29

8
Motor stroke learning
1. Scroll down the parameters with
2. Access the parameter by pressing the
3. When " " flashes, continue pressing the
4. Release the key when "
nect the power supply, inverse the operator cables and repeat the operation);
5. Wait for the door (or doors in case of using 2 motors) searches and stops on the opening stop and then on the closing stop.
If you want to anticipate the stopping strokes in opening, you can manually intervene by giving an impulse to "Start" but-
ton (or pressing the "OK" on the control panel) simulating the stroke.
6. Once the procedure is ended, the display will show "----".
Type 01 and
WARNING (only
closing) and then check the manual release to make sure it is working properly. If it's to "hard" increase the value of P057 of
1 or more.
9
Transmitters learning
9.1 Transmitters coding selection
1. Scroll down the parameters with
P027;
2. Confirm by pressing on the
3. Select the type of transmitter by scrolling
- d000=fix rolling-code (suggested);
- d001=complete rolling-code;
- d002=dip-switch;
4. Confirm by pressing on the
Warning: If you need to vary the type of encoding, and only if other
remotes with different encoding are memorized, you need to erase
memory (P004) AFTER you have set the new encoding.
9.2 Learning
1. Scroll down the parameters with
keys until you visualise P005;
2. Confirm by pressing on the
3. When the symbol "
on any key of the transmitter you want to
memorize;
4. The display visualizes the number of the
transmitter just memorized and then "
5. Memorize all necessary transmitters repeat-
ing this procedure from step 3;
6. Wait 10 seconds before quitting the memo-
rization mode, display shows now "----".
Warning: In the case of rolling code remotes,
the receiver can be put into learning mode
by pressing the hidden button on a remote
control previously learned.
and keys until you visualise P003;
key;
key;
" stops flashing; Start the learning procedure with operator 1 opening (if it starts closing, discon-
Type 03) Once you have executed the learning stroke, operate a complete cycle (opening/
and keys until you visualise
key;
and keys:
key (display shows again P027).
and
key;
" appears, press
";
27